Installation; Mini-Gbic With Mt-Rj Connector - Enterasys SecureStack C2 C2G170-24 Hardware Installation Manual

Installation

To install a Mini‐GBIC with an MT‐RJ connection, refer to Figure
connection, Figure 3‐2; or for an RJ45 connection, Figure
Note: If the Mini-GBIC is one with an RJ45 connector such as an MGBIC-02 (
the installation procedure is the same as described below. However, the Mini-GBIC has a
wire handle to release it.
1. Hold the Mini‐GBIC with its top side facing up and its 7‐pin edge connector facing the
port slot.
2. Carefully align the Mini‐GBIC with the port slot.
3. Push the Mini‐GBIC nto the port slot until the Mini‐GBIC "clicks" and locks into
place.
Figure 3-1
1 Mini-GBIC (MGBIC-MT01)
2 Mini-GBIC
3 7-Pin edge connector (insertion side)

Mini-GBIC with MT-RJ Connector

Á
Ä
Å
top side
,
3‐3, then proceed as follows:
Ã
Â
À
4 Port slot
5 Mini-GBIC
6 Release tab
SecureStack C2 Installation Guide 3-5
Installing an Optional Mini-GBIC
3‐1; for an LC
Figure 3‐3
protective dust cover
,
),