Hardware Installation - Enterasys SecureStack C2 C2G170-24 Hardware Installation Manual

Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Read the Release Notes shipped with the switch to check for any exceptions to the supported
features and operation documented in this guide.
This chapter provides instructions to install the C2G170-24. Follow the order of the
sections listed below to correctly install the switch.
For information about...
Required Tools
Unpacking the Switch
Considerations Prior to Installation
Installing Optional Mini-GBICs
Installing the Switch on a Flat Surface
Connecting High-Speed Stacking Cables
Configuring Switches in a Stack
Connecting AC and RPS Power
Connecting to Console Port for Local Management
Connecting to the Network
Completing the Installation

Hardware Installation

Important Notice
Refer to page...
3-2
3-2
3-2
3-3
3-7
3-11
3-12
3-15
3-17
3-22
3-30
SecureStack C2 Installation Guide 3-1
3