Remote Power Injector Installation - Enterasys RoamAbout AP-2000 Hardware Installation Manual

Remote Power Injector Installation

The remote power injector provides operating power to the AP using the Ethernet cable.
The injector receives input power (via the PWR jack) from either the power module
supplied with the AP or directly from the site facility. If using the power module, install the
injector within six feet of an AC power outlet. The network interface cable plugs into the
NETWORK jack, and the Access Point cable plugs into the ROAMABOUT AP jack.
Pin Network Connector
1 XMIT Data Positive
2 XMIT Data Negative
3 RCV Data Positive
4 No Connection
5 No Connection
6 RCV Data Negative
7 No Connection
8 No Connection
1
2
Remote Power Injector Installation
Access Point
Connector
XMIT Data Positive
XMIT Data Negative
RCV Data Positive
Remote Power 1
Remote Power 2
RCV Data Negative
Remote Power 1
Remote Power 2
Power
Connector
Remote Power 1
Remote Power 2
Cabling and Wiring 2-3