Remote Power Injector Installation; Pin Connectors - Enterasys RoamAbout AP-2000 Hardware Installation Manual

Remote Power Injector Installation

The remote power injector provides operating power to the RoamAbout R2 (referenced in
the following figure as RoamAbout AP) using the Ethernet cable. The injector receives
input power (via the PWR jack) from either the power supply supplied with the
RoamAbout R2 or directly from the site facility. If using the power supply, install the
injector within six feet of an AC power outlet. The network interface cable plugs into the
Network jack, and the RoamAbout R2 cable plugs into the RoamAbout AP jack. Pins and
connectors are listed in
Table 2-1 Pin Connectors
Pin
1
2
3
4
5
6
7
8
1
2
Table
Network Connector
XMIT Data Positive
XMIT Data Negative
RCV Data Positive
No Connection
No Connection
RCV Data Negative
No Connection
No Connection
RoamAbout R2 Wireless Access Platform Hardware Installation Guide 2-3
2-1.
RoamAbout R2 Connector
XMIT Data Positive
XMIT Data Negative
RCV Data Positive
Remote Power 1
Remote Power 2
RCV Data Negative
Remote Power 1
Remote Power 2
Remote Power Injector Installation
Power Connector
Remote Power 1
Remote Power 2