Enterasys RoamAbout AP-2000 Hardware Installation Manual page 40

Surface Wallmount Installation
10. Connect the 10BaseT Ethernet network
cable.
If you are using the remote power
feature, label the end of the cable to the
AP with: CAUTION: Ethernet cable
contains power. Do not use for other
devices.
If you are not using remote power, install
the power module/redundant power
module, if used; refer to
Installation on page
11. Connect the power module into an AC
outlet.
12. Verify power on by observing that some
of the AP LEDs are flashing or lit.
3-12 Installing the Access Point
Power Module
2-6.