Figure 3-3 Installing Module into N1, N3, or N5 Chassis (N3 shown)
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel
Connecting to the Network
"Connecting UTP Cables to 7H4382‐25" on page 3‐12 provides the procedures for
connecting unshielded twisted pair (UTP) segments from the network or other devices.
Æ
Ä
Note: If the DFE-Platinum module is being installed in a network using Link Aggregation,
there are rules concerning the network cable and port configurations that must be followed
for Link Aggregation to operate properly. Before connecting the cables, refer to the
Enterasys Matrix DFE-Platinum Series Configuration Guide for the configuration
information. For details on how to obtain manuals, refer to the
About This Guide
.
Ã
À
Â
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane connectors
DFE-Platinum Series Hardware Installation Guide 3-11
Connecting to the Network
Á
Å
"Related
Documents" in