Connecting To A Modem - Enterasys Matrix 7H4382-25 Hardware Installation Manual

Connecting to COM Port for Local Management
5. With a PC connected to a remote modem, you can configure the switch remotely. To
accomplish this, you must configure your PC VT emulation package with the
following parameters.
6. When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
Figure 3-11 Connecting to a Modem
1 UTP straight-through cable with RJ45 connectors
2 RJ45 COM port
3 RJ45-to-DB25 modem adapter
3-20 Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Å
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Ä Ã Â À
4 Local modem
5 Remote modem
6 PC
Á