Nem Removal And Dram Simm Connector Location - Enterasys Matrix 7H4382-25 Hardware Installation Manual

b. Lift the NEM straight up and off the two module connectors on the main PC
board. For instructions to reinstall the NEM, refer to "Installing Optional
Network Expansion Module (NEM)" on page 3‐2.
Figure B-3

NEM Removal and DRAM SIMM Connector Location

Â
1 NEM
2 Main PC board
3 Screws (3)
2. Refer to Figure B‐4. Push the connector arms away from the memory module to
release it from the connector fingers.
Note: The ejector arms on this connector are not spring loaded, so they will remain in the
open position until manually closed.
3. Remove the module from the connector.
Memory Locations and Replacement Procedures
Â
4 DFE module front panel
5 Module connectors on main board
6 DRAM SIMM memory module
DFE-Platinum Series Hardware Installation Guide B-5
Ä
Â
Á
Å
À