Honeywell BC-200 Operation, Installation & Programming Manual page 71

Panel Operation
7.3.6.9 S
ERVICE
In this screen an AZF may be tested to verify its ability to detect an Alarm or Fault condition.
AZF TEST MENU
DAY MODE
20 JULY 2002 14:44:37
TESTING AZF POINT 1.2.Z3
POINT STATUS:
TEST MODE IS AUTOCLEAR
SENDING ALARM TEST...GOOD RX
WAITING FOR POINT 1.2.Z3 TO ALARM
OK...CLEARING POINT
WAITING FOR POINT 1.2.Z3 TO CLEAR
OK....CLEARING ALARM/FAULT LIST
USE BUTTONS TO SELECT A TEST
ISOL ALARM

All tests will require the operator to manually reset the alarm or fault after the test.

If the alarm test or fault test fails a message of
TIMEOUT ON ALARM/FAULT!!
or
TIMEOUT ON CLEAR!!
If this occurs the module should be immediately investigated for faults.
Note: The AZF tests generate a real alarm or fault condition at the remote module, so the module itself is tested as
well as the panel to module communications.
7.3.6.10 S
ERVICE
Will prompt the operator to enter the device address to be fault or alarm tested.
Note: The Analog tests do not generate a real alarm or fault condition at the device. A successful test is not an
indication of the device's ability to report a real alarm condition, its only an indication of proper
communication between the LCM and FIP.
BC-200 Manual – P/N DOC-01-013
M – T
ENU EST
A = 0
F = 0
I = 0
N = 1
FAULT BACK
M – T
ENU EST
– A /F
LARM AULT
Actions:
An ISOL button is provided so that the point can be
easily isolated during the test period, this button
will toggle to DEISOL if the point is already
isolated.
A single button press of the ALARM or FAULT
buttons is all that is required to initiate the tests.
Pressing the BACK button will return to the previous
screen.
Note that an isolated point is seen as inactive by the
panel and hence, in a logic programming script, it
will return the value FALSE (or TRUE if the NOT
function is applied to it within the script).
– A /F
LARM AULT
– AZF
– A
NALOG
71