Honeywell BC-200 Operation, Installation & Programming Manual page 111

Appendix
9.6.1.1 POWER SUPPLY CONNECTIONS - PS243 & PS249
9.6.1.2 P
OWER
The following settings are used when connecting a NPS power supply to an IFS-724 FIM using the ribbon cable:
1. The CPU must have V5.02 or above firmware installed.
2. Set the bottom dipswitch on mode dipswitch U25 (on the back of the CPU) to the on position. Note that the
dipswitch can be marked 1 or 4. Always set the dipswitch closest to the upload/download port.
3. J6 on IFS-724 FIM board must be fitted.
Refer to Power
Supply Interface
(PSI) Manual for
more information
BC-200 Manual – P/N DOC-01-013
IFS-704/714/724 TERMINATION BOARD
S C
UPPLY ONNECTIONS
Fit Link at J6
NI-2012
Power Supply
Interface (PSI)
NI-2012 (PSI) Dipswitch Settings:
Normal operation: All off
NZ Operation: 1 on, all others off
Manual mode: 2 on, all others off
TERM 2
- NPS-2/5/11
IFS-724 FIM
Termination Board
111