Table of Contents
Advertisement
Wire harness
1
Guide, wire
2
Route the fuel breather hose along
3
the upper of the main harness.
Route the oil breather hose
4
along the upper of the main har-
ness.
Install the tail / brake light lead
5
behind the instrument panel.
Make sure that the oil tank cap
6
and oil breather hose do not
touch each other.
Route the tail / brake light lead
7
between the fuel tank and the
snowmobile body. Make sure
that the fuel tank does not crush
the tail / brake light lead. Then,
fasten the three pieces of adhe-
sive tape below the fuel tank as
shown.
50 mm (1.97 in)
8
To tail / brake light
9
Adhesive tapes
10
Pass the wire harness and fuel
11
tank breather hose through the
cable hlder.
Clip
12
Fuel sender coupler
13
Oil level switch coupler
14
Install the metal clip facing down-
15
ward
Insert the fuel tank breather hose
16
until it can not be inserted further
To carburetor left side
17
To carburetor right side
18
Pulser hose
19
Oil hose
20
CABLE ROUTING
–84–
SPEC
Advertisement
Table of Contents
