Wire harness
1
Does not kink.
2
50 mm (1.97 in)
3
Route the fuel breather hose
4
along the upper of the main
switch harness.
Route the oil breather hose
5
along the upper of the main
switch harness.
Install the tail / brake light lead
6
behind the instrument panel.
Make sure that the oil tanl cap
7
and oil breather hose do not
touch each other.
Route the tail / brake light lead
8
between the fuel tank and the
snowmobile body. Make sure
that the fuel tank does not crush
the tail / brake light lead. Then,
fasten the three pieces of adhe-
sive tape below the fuel tank as
shown.
50 mm (1.97 in)
9
To tail / brake light
10
Fuel tank
11
Compression spring
12
Clip
13
Fuel sender coupler
14
Oil level switch coupler
15
Install the metal clip facing down
16
ward.
Insert the fuel tank breather hose
17
until it can not be inserted further.
Fuel hose
18
Pulser hose
19
Oil hose
20
CABLE ROUTING
–98–
SPEC