ELNA 344 Instruction Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
Your 344 overlock machine is designed and constructed for HOUSEHOLD
use only. Read all instructions before using this overlock machine.
DANGER
- To reduce the risk of electrical shock:
1. Your overlock machine should never be left
unattended when plugged in.
2. Always unplug the machine from the electrical
outlet immediately after using and before cleaning.
3. Always unplug before replacing light bulb. Replace
bulb with same type rated 240V/15W, 230V/15W or
115V/15W.
4. Do not place or store machine where it can fall or be
pulled into a tub or sink. Do not place it in or drop it
into water or other liquid.
5. Do not reach for the machine if it has fallen into
water. Unplug immediately.
WARNING
- To reduce the risk of burns, fire,
electrical shock or injury:
1. Do not allow the machine to be used as a toy.
Supervision is necessary when this machine is used
by or near children.
2. Use this machine only for its intended use as
described in this manual. Use only attachments
recommended by the manufacturer as described in
this manual.
3. Never operate this machine if it has a damaged cord
or plug, is not working properly, has been dropped
or damaged, or dropped into water. Return the
machine to the nearest authorized dealer or service
center for examination, repair, electrical or
mechanical adjustment.
SAVE THESE INSTRUCTIONS
FOR USA/Canada
This appliance has a polarized plug (one blade wider than the other). To reduce the risk of electric
shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Must use foot control 4C-316B (120v), 4C-316C (220v), 4C-326C (240v) or 4C-326G (230v).
4. Never operate the machine with any air opening
blocked. Keep ventilation openings of the machine
and foot control free from accumulation of lint,
dust and fibers.
5. Keep fingers away from all moving parts. Special
care should be used around the needle and cutting
blades.
6. Do not use bent needles.
7. Do not pull or push fabric while stitching. This may
deflect the needle causing it to break.
8. Switch off the machine when making any
adjustment in the needle area, such as threading
needle, changing needle position, threading looper,
changing presser foot, etc.
9. Always unplug the machine from the electrical
outlet when removing covers, lubricating or when
making any other servicing adjustments mentioned
in this instruction manual.
10. Never drop or insert any object into any opening.
11. Do not use outdoors. Always store your machine
indoors.
12. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
13. To disconnect, switch machine off, then remove
plug from outlet.
14. Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
15. This machine is equipped with a special connection
cord which, if damaged, must be replaced by an
identical cord. This can be obtained from an
authorized dealer or service center.
2