D-Link DIR-410 User Manual page 29

use the LAN IP address of this device as their Default Gateway. You can change it if
necessary.
2. 3G Failover: When the 3G connection is interrupted, the connection of router would
automatically shift to wired line.
3. IP Mode: Please check the IP mode your ISP assigned, and select "Static IP Address" or
"Dynamic IP Address".
4. My IP Address and My Subnet Mask: The private IP address and subnet mask your ISP
assigned to you.
5. Gateway IP and Server IP Address/Name: The IP address of the PPTP server and
designated Gateway provided by your ISP.
6. PPTP Account and Password: The account and password your ISP assigned to you. If
you don't want to change the password, keep it blank.
7. Connection ID: Optional. Input the connection ID if your ISP requires it.
8. Maximum Idle Time: the time of no activity to disconnect your PPTP session. Set it to
zero or enable "Auto-reconnect" to disable this feature. If Auto-reconnect is enabled, this
device will connect with ISP automatically after system is restarted or connection is
dropped.
9. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send outgoing
packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
Manually: The device will not make the link until someone clicks the connect-button in
the Status-page.
10. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTU value is 0 (auto).
F. L2TP
29