Advertisement
Drive Type
The programming device PG 760 PII is equipped with a floppy disk drive, a
hard disk drive and a CD-ROM drive as standard.
SIMATIC Memory
You can read, program and erase SIMATIC Memory Cards via the 68-pin
Cards
connector.
Figure 1-3
Please note the following instructions while working with memory cards.
Caution
!
Risk of damage to memory cards and to your programming device
PG 760 PII!
You must insert the memory card into a 68-pin connector with the type label
on top of it. The points of orientation on the memory card and on the slot
have to correspond with each other.
If you try to plug the memory card in the wrong way around, your
programming device or memory card will be damaged!
You must not take out the SIMATIC memory card as long as the LED for the
memory card interface is lit.
In order to program SIMATIC memory cards select the submenu "Hardware
Options" under BIOS-Setup and set "Programming interface" "enabled".
6
Point of orientation
SIMATC Memory Cards
SIMATIC Memory Cards Interface
PG 760 PII Product Information Bulletin
C79000-K7076-C767-01
Advertisement
