Advertisement
Selecting Mains
If the voltage displayed on the system selector switch does not correspond
Voltage
with your local voltage, you must move the mains voltage selector so that the
voltage set next to the triangle is visible.
To do this, use a small, flat screwdriver to lever out the part with the voltages
printed on it and replace it in the appropriate position.
Caution
!
Risk of damage to the unit!
Operating the PG 760 PII with the incorrect mains voltage can damage the unit,
since the input voltage is also applied to the mains outlet.
To operate the monitor, observe the manufacturer's specifications.
Only a monitor with the following rated currents may be connected:
Figure 1-2 Mains Voltage Selector
Switching on
After you have checked the right setting of the mains voltage selector and
connected all cables required for operation, you can switch on your
programming device. When you switch on the ON/OFF switch at the back of
the power supply unit, the red Power LED on the front panel lights up
(Standby: the device is connected to the mains voltage). Now switch on the
switch behind the drive cover in the centre of the front panel to change from
standby to operating mode.
PG 760 PII Product Information Bulletin
C79000-K7076-C767-01
120 V
3 A max.
240 V
1.5 A max.
Power supply
connector socket
(out)
Power supply
connector socket
(in)
Mains voltage
selector
On/Off switch
Microphone
Loudspeaker
5
Advertisement
