Sds Remote Control; Setting Remote Control; Setup - Motorola MTP6650 Feature User Manual

Play loud tone until user interaction
The radio plays a loud tone as in the Man Down (henceforth known as Fall Alert) feature until you
unlock the keypad (if needed) and press the appropriate soft key labeled Exit. The tone is played
through the speaker even if an accessory is attached.
The tone is not emitted when the radio is in one of the following states:
• In a call
• Temporarily disabled
• Pseudo Off Mode
• Ambience Listening Mode
• Transmit Inhibit Mode (TXI)
• Emergency Mode
• Silent Emergency Mode
• Covert Mode
Send firmware version and TEI
The radio sends back an SDS message with its firmware version and TEI.
NOTE: If the sending Individual Short Subscriber Identity (ISSI) is not on the Allowed ISSIs list,
the receiving radio ignores the task.
4.9.7.2

SDS Remote Control

NOTE: This is a Software Selling Feature. Only one type of remote control can be active on a
radio; either SDS or Status.
SDS Remote Control is a feature that enables remote control and configuration of the radio using
special SDS messages. The messages can be sent both in TMO and DMO (including the Repeater
Mode) by any radio capable of controlling other radios. During the execution of the Remote Control
messages, depending on your service provider settings, the radio can play a tone, vibrate, or display
an appropriate icon in the status icon area.
4.9.7.3

Setting Remote Control

This procedure describes how to toggle remote control.
Procedure:
1 From the home screen, press the Menu key.
2 Select Security→Remote Control.
3 Select On to enable, or Off to disable remote control.
4.10

Setup

The Setup menu allows you to change the general configuration on your radio.
MN005826A01-AE
Chapter 4 : Main Menu
103