Sds Remote Control; Figure 6: Sds Remote Control Overview - Motorola MTP830 S Product Information Manual

Services and Features | 63
TMO
TMO
DMO
When the radio connects to a gateway, it plays a tone, displays the Gateway available message and shows an
appropriate icon. When the radio looses connection with the gateway, it plays a tone, displays the Gateway not
available message, and the gateway icon is blinking.

SDS Remote Control

The SDS remote control feature enables controlling a radio through Air Interface using SDS-TL bearer service. A
controlling terminal (for instance, a controlling radio or SwMI controlling terminal) sends the SDS remote control
messages with AT commands to be executed by the radio.

Figure 6: SDS remote Control Overview

C o n tro lle d Radio
S w M I
T M O
C o n tro llin g T erm in al
T M O/DMO
Radio T E
C o n tro llin g Terminal
The SDS remote control functionality works in both TMO and DMO and the remote control PDUs are sent using
terminal equipment (TE).
You can use the feature only after a successful authorization, which requires entering a valid remote control PIN
number.
The remote control messages can be sent to a group or individual radios.
A controlled radio receives over the air control information using SDS type 4 with TL on the specific PID number
defined in the codeplug. If the received control message is originated from one of ISSIs present on the radio
authorized ISSI list, the radio executes received command and sends a response.
| | Send Feedback