Table of Contents
Advertisement
Operation
Your First Fire
Read these instructions carefully and familiarize yourself
with the burner controls. Locate the pilot assembly, Figure
46.
During the first fire, it is not unusual to smell some odor
associated with new logs, paint and metal being heated.
Odors should dissipate within an hour or so, however, you
can open a window to provide fresh air to alleviate the
condition.
!
Odors and vapors released during initial operation
• Curing of high temperature paint
• Open windows for air circulation
Odors may be irritating to sensitive individuals.
Pilot and Burner Inspection
Each time you light your heater check that the pilot flame
and burner flame patterns are as shown in Figure 48. If
flame patterns are incorrect, turn the heater off. Contact
your dealer or a qualified gas technician for assistance. Do
not operate the heater until the pilot flame is correct.
Pilot Assembly
Figure 46 - Pilot assembly location.
ST769
Dutchwest
pilot location
5/15/03 djt
3-90-693831
Hearth and Home Technolgies • Oxford Direct Vent Installation Manual_R6 • 08/17
CAUTION
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjustment
is accomplished by rotating the HI/LO adjustment knob
located near the center of the gas control valve. (Figure 47)
Turn
counterclockwise
to decrease
flame height
Figure 47 - Flame adjustment knob for Honeywell valve.
Flame Characteristics
It is important to periodically perform a visual check of the
pilot and the burner flames. Compare them to Figure 47. If
any of the flames appear abnormal, call a service person.
Red
Glow
Figure 48 - Correct pilot and burner flame patterns.
Turn clockwise
to increase
flame height
HV102
Honeywell hi/lo knob
4/5/99 djt
CO105c
Pilot flame
4/10/00 djt
LG142
Stardance
Install logs 2
12/11/00 djt
24
Advertisement
Table of Contents
