Installation; Levelling Of Stove; Connections - Jøtul PF 732 Installation, Operation And Maintenance Manual

2
1) Permitted insulating material
2) Steel pipe
3) Closing pane

6 INSTALLATION

The fitter must have the Jøtul certificate, authorising
installation of appliances fired with solid fuel.
6�1 LEVELLING OF STOVE
The stove must be positioned horizontally and vertically
by means of a level gauge. Levelling can be adjusted by
means of adjustable feet (fig. 6.1). Unscrew the feet until
the mounted nuts are reached.
A B = Level gauge
1
3
fig� 5�5�2
AB
fig� 6�1
6�2 CONNECTIONS
6�2�1 Electrical connection
It is enough to connect the stove to the electrical grid by
means of a plug.
The electrical connection (socket) must be easily
accessible after installation of the stove and must remain
visible.
If the power cord is damaged, it must be replaced by a
qualified technician in order to avoid risk�
6�2�1�1 Grounding
The installation must strictly be equipped with grounding
and a breaker switch in accordance with binding standards
(fig. 6.2).
The metal chimney flue must have its own connection to
ground�
6�2�2 Connection to an external chronothermostat
It is possible to connect an external chronothermostat,
which extinguishes and ignites the stove depending on
the programmed temperature.
After reaching the set temperature, the thermostat
opens the circuit and shuts down the stove.
The external thermostat must be connected to two
terminals found on the electronic card, which were
previously connected at the factory. Disconnect both
terminals and connect the two contacts of the thermostat
to them.
It is important to set the stove to configuration 2,
proceeding according to the instructions given in the
"Initial configuration" section.
After installation of the chronothermostat, the first
firing of the stove must be performed manually, when
the chronothermostat is in "call" mode� Proceed in the
same manner after power failure as well as after manual
shutdown of the stove�
To prevent the thermostat's operation from interfering with
the time intervals of the stove's work, it is recommended
to deactivate (set to OFF) the stove's time breaker switch
(see section 10�1)�
ENGLISH
fig� 6�2
9