Table of Contents
Advertisement
im Vertrieb von
Operation, cont'd
Display
Menu
Cycle
Figure 3-5 — Input Configuration menu flowchart
Input #2 submenu
Rotate either the Adjust
select the correct video format (RGB, YUVi, YUVp, Betacam 50, Betacam 60, or
HDTV) for input 2. The default for input 2 is Betacam 60.
Pixel Phase submenu
The Pixel Phase submenu displays and lets you set the pixel phase for the selected
input. Pixels phase is the timing of the digital scaler's sampling. Sampling at the
optimum pixel phase reduces noise and results in a clear and sharp image.
Rotate either the Adjust
selected input from 0 to 31. You can select the unselected input while this screen is
active by pressing the desired Input button. The default is 16.
Output Configuration menu
Figure 3-6 is a flowchart that shows an overview of the Output Configuration
menu, the submenus, and the available settings.
Input
Configuration
MENU
Output
Configuration
MENU
Memory
Presets
Scaler output resolutions
See the table on the
opposite page for available
combinations of resolutions
and refresh rates.
Default: 1024x768, 60 Hz
Figure 3-6 — Output Configuration menu flowchart
www.camboard.de
3-6
Digital Display Scaler • Operation
CAMBOARD Electronics
Input
Input #2
Next
Configuration
Betacam 50
Input video type
• RGB
• YUVi
• YUVp
If you press the Menu button while a main menu or a submenu is active, the
next main menu becomes active. For example, the display changes from the
Input Configuration main menu or the Input #2 submenu to the Output
Configuration main menu.
To return to the default screens, let the DDS 402 remain idle for 10 seconds
until the selected screen times out, or press the Menu button until the Exit
Menu appears, then press the Next button.
or the Adjust knob while in the Input #2 submenu to
or the Adjust knob to select the pixel phase for the
The pixel phase adjustment for input 2 is only available when the input type is
set to RGB, YUVp, or HDTV.
Resol 1024 x 768
NEXT
NEXT
Refresh @ 60
Scaler output frequencies
NOTE
Lock = Accu-RATE
Frame Lock™
Tel. 07131 911201
Fax 07131 911203
Input #2 Phase
Next
1
2
The selected input is
also available for the
pixel phase adjustment
(next screen).
Use either Adjust
knob to set the
• Betacam 50
• Betacam 60
slected output's
• HDTV
pixel phase.
Output Signal
NEXT
RGB
H Neg
Output signal format
Polarity combinations
• RGB
• H-/V- (default)
• H-/V+
• Y, R-Y, B-Y
ce-info@camboard.de
NEXT
Next
016
Sync Polarity
NEXT
V Neg
• H+/V-
• H+/V+
Advertisement
Table of Contents
