Wet System - Husqvarna K1270 Workshop Manual

20. WET SYSTEM

20.1. DESIGN
A spray nozzle is located on each side of the
blade guard. The water strikes a section of the
cutting blade and the centrifugal force carries it out
towards the blade's diamond segment.
The spray nozzles are available with several
different hole diameters depending on the type of
machine and application. Find the right nozzle in
the spare parts list.
20.2. REPLACING THE SPRAY
NOZZLES
The intake is located with special screws that direct
the water to the spray nozzles underneath.
1. Remove the screw.
2. Remove the spray nozzle.
FIT THE RIGHT DIMENSION
Check in the spares list that the spray nozzle with
the correct dimension is fitted.
LIGHT TIGHTENING
The spray nozzles have a thin material between
the outer and inner thread. Tighten the spray
nozzles with a light force.
20.3. FILTER REPLACEMENT
A normal wood screw works excellently as a
removal tool for the filter. Screw the screw into the
filter and pull this out.
Fit the filter by pressing it in on a flat surface.
20.4. HOSE CLIPS
The hose clips in the wet cutting system are of the
type that can be reused. Open the hose clip by
pushing up the lock catch with a screwdriver.
Close the hose clip by pressing it together with
some pliers.
WET SYSTEM - DESIGN
WET SYSTEM - REPLACE SPRAY NOZZLE
WET SYSTEM - FILTER REPLACEMENT
WET SYSTEM - HOSE CLIPS
Wet system
2
1
75
English -