Husqvarna K1270 Workshop Manual page 67

18.3. ASSEMBLY
PISTON STOP
Lock the crankshaft's travel using the piston stop
504 91 06-05 instead of the spark plug. Tightening
torque 26–30 lbf·ft/35–40 Nm.
NOTE! For reasons of safety it is important that
the clutch is assembled with the right tightening
torque. Use a torque wrench.
18.4. CLUTCH SPRINGS
DISMANTLING
1. Secure the clutch in a vice.
2. Place a large screwdriver against the spring
hook. Knock the screwdriver with your hand to
release the spring hook and avoid rehooking.
3. Push out the spring hook using a pin punch.
CLEAN THE CLUTCH
When the springs have been removed the clutch
can be dismantled. Check that the shoes can move
easily in their races. Clean if necessary.
NOTE! Do not lubricate the clutch! Note that
the clutch does not need to be lubricated.
TIGHTENING
1
DISMANTLING THE CLUTCH SPRINGS
CLEAN THE CLUTCH
Clutch
2
67
English -