Husqvarna K1270 Workshop Manual page 61

Clutch side
4. Heat the bearing seat on the clutch side to
about 200 °F/100 °C.
5. Support the crankcase with wooden blocks
as close to the crankshaft as possible. Knock
out the crankshaft from the crankcase using a
plastic hammer.
CONNECTING ROD
6. Check that there is no radial play on the
connecting rod by the crankshaft journal. If
this is the case the whole unit, crankshaft and
connecting rod, must be replaced.
CLEAN THE GASKET SURFACES
7. Carefully clean the gasket surfaces. No gasket
residue must remain.
DIVIDING THE CRANKCASE STEP 3
DIVIDING THE CRANKCASE STEP 4
CONNECTING ROD
Crankcase
61
English -