Horizontal Alignment; Setting Up The Appliance; Measures To Be Noted During Transport - Bosch HGG933150J Instruction Manual

accessible so that you can disconnect the appliance from the
electricity supply if necessary.
Please ensure the availability of a multi-pin disconnecting
■
system.
Never use extension cables or multiple plugs.
■
For safety reasons, this appliance must only be connected to
■
an earthed connection. If the safety earth terminal does not
comply with regulations, safety against electrical hazards is
not guaranteed.
You must use a H 05 W-F type cable or equivalent for the
■
appliance connection.

Horizontal alignment

Always set up the appliance directly on the kitchen floor.
The appliance is equipped with adjustable feet to set the height.
You can raise the appliance approximately 15 mm by adjusting
the feet.
The adjustable feet are located at the front and rear corners
underneath the oven.
You can adjust the feet, using a spanner, to ensure that the
appliance is horizontal.
6

Setting up the appliance


The appliance must be set up directly on the kitchen floor
■
and in line with the specified dimensions. The appliance must
not be set up on any other object.
The distance between the top edge of the oven and the
■
bottom edge of the extractor hood must meet the
PD[
requirements of the extractor hood manufacturer.
 PP
Ensure that the appliance is not moved again after set up.
■
The distance from the high output burner or wok burner to
the fronts of adjacent units must be at least 50 mm.

Measures to be noted during transport

Secure all mobile parts in and on the appliance using an
adhesive tape that can be removed without leaving any traces.
Push all accessories (e.g. baking tray) into the corresponding
slots with cardboard at the edges, in order to avoid damaging
the appliance. Place cardboard or similar between the front and
rear side to prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the appliance
sides using adhesive tape.
Keep the original appliance packaging. Only transport the
appliance in the original packaging. Observe the transport
arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to guarantee
sufficient protection against any transport damage.
Transport the appliance in an upright position. Do not hold the
appliance by the door handle or the connections on the rear, as
these could be damaged. Do not place any heavy objects on
the appliance.
0LQ