Operations Flow - Panasonic WJ-NX400K/GJ Installation Manual

Operations flow

• Professional knowledge on and experience in network and the HDD are required for
the settings and changes of the operation.
• The main monitor is required for the settings.
* The settings can be done through a web browser on the PC (Refer to the Operating
Instructions (PDF)).
• The PC is required for reading the Important Information, the Operating Instructions
(PDF) and camera settings.
Obtain the license (Registration Key)
1
☞ Page 12 and Activation Key Card
2
3
Turn on the devices
4
Register the license (Registration Key)
5
Assemble HDD unit
6
10
Rack mounting
☞ Page 13
Connections
☞ Page 15
☞ Page 27
☞ Page 29
☞ Page 31
Obtain the "Registration Key" of the recorder by following the
instructions on the provided Activation Key Card. To
increase the number of connected cameras or use the
secure function, get the registration key of the additional
license according to the appropriate Additional Kit (option).
The obtained "Registration Key" will be used in Step 5.
Install the recorder in the rack. (☞ Page 13) Go to step 3
when not installing it in the rack.
Connect the recorder to each device.
Turn on the power to launch in the following order.
①Turn on the power of the camera and the monitor.
② Turn on the power of the extension unit if connected.
③Turn on the power of the recorder.
Register the Registration Key of the recorder. If necessary,
register the "Registration Key" for the Additional Camera Kit
or the Secure Communication Kit.
Important:
• Be sure to register the "Registration Key" of the recorder.
If the "Registration key" of the recorder is not registered,
the Additional Kit cannot be registered.
After registration, click [Restart] button on the license
registration screen to reboot the recorder and activate the
license.
To install a hard disk drive in the recorder, it is necessary to
assemble an HDD unit (encase the hard disk drive in the
HDD canister).