How To Use The Terminals Of The Alarm In - Panasonic WJ-NX400K/GJ Installation Manual

3 Connections

How to use the terminals of the ALARM IN

ALARM IN terminals on the back are used to connect the alarm devices such as sensors, door switches, etc.
Insert the unarmored cable into the provided terminal plug (16 pin) and then mount it on the ALARM IN terminal on the back.
* The cable should be a single or twisted wire with AWG 26~16 and an exposed length of 9 mm {11/32 inches}.
* Tie cables of the ALARM/CONTROL connectors and of the ALARM IN connectors, and fix them with the cable clamp (provid-
ed). Refer to "Major Operating Controls and Their Functions"of the Important Information for further information.
ALARM IN terminal on
the back
Pin array
Pin No. Signal
A1 Alarm input 1
A2 Alarm input 2
A3 Alarm input 3
A4 Alarm input 4
A5 Alarm input 5
A6 Alarm input 6
A7 Alarm input 7
A8 Alarm input 8
A9 Alarm input 9
A10 Alarm input 10
A11 Alarm input 11
A12 Alarm input 12
A13 Alarm input 13
A14 Alarm input 14
A15 Alarm input 15
A16 Alarm input 16
B1 Alarm input 17
B2 Alarm input 18
B3 Alarm input 19
B4 Alarm input 20
B5 Alarm input 21
B6 Alarm input 22
B7 Alarm input 23
B8 Alarm input 24
B9 Alarm input 25
B10 Alarm input 26
B11 Alarm input 28
B12 Alarm input 28
B13 Alarm input 29
B14 Alarm input 30
B15 Alarm input 31
B16 Alarm input 32
24
(continued)
B1 A1
B16 A16
ALARM IN
Operation
Event action will be performed according to the
settings
Connections
① Loosen the screw of the desired
terminal on the terminal plug.
② Tight the screw when the cable is
fully inserted into the terminal hole.
③ Mount the terminal plug with the
cable connected on the alarm
input terminal socket on the back.
A1 (B1) side
Terminal plug (16 pin)
Remarks
Non-voltage make contact input