Panasonic WJ-NX400K/GJ Installation Manual page 22

3 Connections
Connection example 2 for the auto adjustment time function
When "Auto time adjustment" found in "Date & time settings" under "Date/Language" on the setup menu is set to
"Slave".
When a signal output from the other device is supplied to the time adjustment input (C5 terminal) and the time difference between
the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other device.
When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour
(nn:00:00). ("nn" is the hour.)
Example:
• Signal is supplied at 2:50:00 pm → Set at 3:00:00 pm
• Signal input supplied at 3:28:45 pm → Set at 3:00:00 pm
• Signal is supplied at 3:29:30 pm → Time will not be adjusted.
D1
D12
Important:
• When "Slave" is selected, the clock will not be adjusted during event recording or emergency recording.
Connection example of control output
When an alarm device such as a buzzer or a lamp is connected, the signal output from terminal D5~9 can be used to notify the
status by sounding a buzzer or lighting a lamp.
The following example is of a connection with the HDD error output (D6 terminal).
Alarming device
22
(continued)
C1
C5
(Time adjustment I/O)
C11 (Signal ground)
Relays, etc.*
* Attached when necessary
Terminal of the other device
Front panel
LED monitor
output
D1
(HDD error output) D6
D11
(Signal ground)
C1
C12