Operations During Playback - Panasonic WJND400 - NETWORK DISK RECORDER Operating Instructions Manual

Playback

Operations during playback

Function
Playback/reverse playback
Stop
Pausing
Frame play/reverse frame
play
Skip/reverse skip
Fast playback/fast reverse
playback
Skip to the latest image
20
Button
• Plays recorded images.
• Plays recorded images in reverse.
Note:
• Clicking the [Play] or [Reverse play] button while recording at a low rate
may not play the images being recorded either forward or reverse.
• Clicking during playback stops playback and displays the live image.
• Clicking during playback pauses play back.
• Clicking while paused restarts playback.
• Clicking [NEXT IMAGE] during play or pause plays one frame at a time in
forward, or pauses.
• Clicking [PREV IMAGE] during play or pause plays one frame at a time
backward, or pauses.
Note:
• Not all recorded images are displayed if the image being played back is
MPEG-4. Single frame reverse occurs at the refresh rate set for the
camera.
• Clicking [NEXT RECORD] starts playing preceding images.
• Clicking [PREV RECORD] starts playing previous images.
• If the skip destination does not exist, playback continues. In this case, the
play time may go back one minute.
• Each time the [FF] button is clicked, the speed changes, Step 2 (4x), Step
3 (8x), Step 4 (16x), Step 5 (32x), Step 6 (48x), Step 7 (96x).
• Each time the [REW] button is clicked, the reverse speed changes, Step 2
(4x), Step 3 (8x), Step 4 (16x), Step 5 (32x), Step 6 (48x), Step 7 (96x).
• Clicking the [PLAY] or [REV PLAY] button during fast forward or reverse
changes the speed to normal speed.
Note:
• Not all recorded images can be displayed if the image being played back
is MPEG-4. Fast forward/reverse is played back at the refresh cycle set
on the camera.
[Go to last] • Skips to the latest image and starts playback. The default setting is to skip
to 30 seconds before the most recent image.
The settings for skipping to the latest image are shown below.
5s/10s/30s/1min/5min
For information about settings, contact your system administrator.
Note:
• Clicking the [Go to last] button while recording at a low rate, the latest
image being recorded may pause or may not be displayed.
Operation