Front - Mercedes-Benz 2011 CL-Class Operator's Manual

Vehicle
238
X
To move to the lower menu bar: select
by sliding ZVÆ the COMAND controller
and press W to confirm.
i When you press the T function button,
the previously adjusted seat is active.
X
To adjust the lumbar support: select by
sliding XVY or turning cVd the COMAND
controller and press W to confirm.
Multicontour seat
i Information about the components and
operating principles of COMAND can be
found on ( Y page 108).
The contour of the driver's seat and front-
passenger seat backrests can be individually
adjusted to provide optimum support for your
back. This is achieved by controlling the
pressure in the air chambers in the
multicontour seat.
The adjustments are made using the
COMAND display.
i When you adjust the multicontour seat,
you may hear the air being pumped in or
released.
You can adjust the following air cushions:
seat side bolsters
R
seat backrest side bolsters
R
backrest curvature in the lumbar region
R
backrest curvature in the upper back
R
region
X
Make sure that the key is in position 2 in
the ignition lock.
X
Press the T function button.
Selecting the seat
You must first select the seat for which you
wish to make adjustments.
X
Press the T function button.
The main area is active.
X
To move to the lower menu bar: select
by sliding ZVÆ the COMAND controller
and press W to confirm.
X
To select a seat: select by sliding XVY or
turning cVd the COMAND controller and
press W to confirm.
Exiting a menu
There are several ways of exiting the menu for
the multicontour seat:
X
Press the T function button again.
or
X
Press any function button.
or
X
Select another main function from the
basic menu.
Display values
Two values are displayed on the setting scale
if you adjust the multicontour seat:
Red: this is the set value which you specify
R
when making the adjustment.
White: this is the current actual value,
R
which is slowly brought into line with the
set value.