Convenience Opening Feature - Mercedes-Benz 2011 CL-Class Operator's Manual

Side windows
86
Opening and closing the side
windows
Front left
:
Front right
;
Rear right
=
Rear left
?
The switches for all side windows are located
on the driver's door. There is also a switch on
the front-passenger door as well as on the
doors in the rear compartment on the left and
right-hand sides for the respective side
window.
i It is not possible to operate the door
windows from the rear compartment when
the override feature is activated for the
door windows.
X
Turn the SmartKey to position 1 in the
ignition lock.
X
To open: press the corresponding switch.
X
To close: pull the corresponding switch.
i You can start automatic operation when
opening and closing the front door windows
and when opening the rear door windows.
To do so, briefly press or pull the switch to
just beyond the point of resistance in the
relevant direction. You can stop automatic
operation by pressing or pulling again.
i You can continue to operate the side
windows after you switch off the engine.
This function remains active for five
minutes or until one of the doors is opened.
Convenience opening
You can ventilate the vehicle before you start
driving. To do this, you can use the SmartKey
to simultaneously:
open the side windows
R
open the sliding sunroof
R
switch on the seat ventilation of the driver's
R
seat
i
The convenience opening feature can
only be operated using the SmartKey. The
SmartKey must be close to the driver's
door handle.
X
Point the tip of the SmartKey at the driver's
door handle.
X
Unlock the vehicle by pressing the %
button.
X
Press and hold the % button until the
side windows and the sliding sunroof are in
the desired position.
X
To interrupt the convenience opening:
release the % button.
Convenience closing
General information
When you lock the vehicle, you can
simultaneously:
close the side windows
R
close the sliding sunroof
R
G
Warning
When closing the door windows and the
sliding sunroof, make sure that there is no
danger of anyone being harmed by the closing
procedure.
If potential danger exists, proceed as follows:
Release the & button to stop the closing
R
procedure. To open, press and hold the
% button. To continue the closing
procedure after making sure that there is
no danger of anyone being harmed by the