Care; Washing By Hand - Mercedes-Benz 2011 CL-Class Operator's Manual

G
Warning
The vehicle is braked when the HOLD function
or DISTRONIC PLUS is activated. Therefore,
deactivate the HOLD function and DISTRONIC
PLUS before the vehicle is washed in an
automatic car wash.
You can wash the vehicle in an automatic car
wash from the very start.
! It is preferable to use car washes with
26
adjustable high-pressure precleaning. In
car washes that use high water pressures,
there is a risk that a small amount of water
may leak into the vehicle.
! Never clean your vehicle in a Touchless
Automatic Car Wash as these use special
cleaning agents. These cleaning agents can
damage the paintwork or plastic parts.
If the vehicle is very dirty, pre-wash it before
cleaning it in an automatic car wash.
! In car washes with a towing mechanism,
make sure that AUTOTRONIC is in
transmission position N, otherwise the
vehicle could be damaged.
Vehicles with a SmartKey:
R
Do not remove the SmartKey from the
ignition lock. Do not open the driver's
door or front-passenger door when the
engine is switched off. Otherwise,
AUTOTRONIC selects park position P
automatically and locks the wheels. You
can prevent this by shifting AUTOTRONIC
to N beforehand.
Vehicles with KEYLESS-GO:
R
Do not open the driver's door or front-
passenger door when the engine is
switched off. Otherwise, AUTOTRONIC
selects park position P automatically and
locks the wheels.
Observe the following to make sure that the
automatic transmission stays in position N:
26 Corresponds to the specification for the Cabriolet program.
X
Make sure the vehicle is stationary and the
ignition is switched off.
X
Turn the key to position 2 (
the ignition lock.
Use the key instead of the Start/Stop
button on vehicles with KEYLESS-GO.
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to
position N.
X
Release the brake pedal.
X
Release the parking brake.
X
Switch off the ignition and leave the key in
the ignition lock.
! Make sure that the side windows are
completely closed, that the ventilation/
heating is switched off and that the
windshield wiper switch is set to 0.
Otherwise, the rain/light sensor could be
activated, triggering unintended wiper
movements. This can cause damage to the
vehicle.
After using an automatic car wash, wipe off
wax from the windshield and the wiper
blades. This will prevent smears and reduce
wiping noises caused by residue on the
windshield.

Washing by hand

Carefully remove all deposits of road salt as
soon as possible when driving in winter.
Also, clean the insides of the wheels when
washing the underbody of the vehicle.
X
Do not use hot water and do not wash the
vehicle in direct sunlight.
X
Use a soft car sponge for cleaning.
X
Use a gentle cleaning agent, e.g. a
Mercedes-Benz approved car shampoo.
X
Wash down the vehicle with a gentle water
jet.
X
Do not point the water jet directly at the air
inlets.

Care

411
Y page 267) in
Z