Smeg SFPA9305SPX Manual page 81

5. Touch the START
pyrolytic cycle.
It is not possible to start the
pyrolytic cycle if the temperature
probe is plugged in.
The appliance will emit an error
signal each time the START
button is pressed.
Two minutes after the pyrolytic cycle has
started, the door is locked (the
appears on the display) by a device that
prevents the door from being opened.
It is not possible to select any
function once the door lock device
has been activated. It remains
possible, however, to switch off the
appliance using the specific
controls.
End of the Pyrolytic cleaning cycle
At the end of the pyrolytic cycle, a buzzer
sounds briefly, which can be deactivated
by touching any point of the display.
The door remains locked until the
temperature inside the oven returns to a
safe level.
Cleaning and maintenance
button to start the
symbol
A message will appear on the display to
indicate that the oven cavity cooling
procedure is in progress.
• Wait for the oven to cool down and
collect the residue deposited inside it
using a damp microfibre cloth.
During the first pyrolytic cycle,
unpleasant odours may occur due
to the normal evaporation of oily
manufacturing substances. This is
an absolutely normal phenomenon
which disappears after the first
pyrolytic cycle.
During the pyrolytic cycle the fans
produce a more intense level of
noise due to a greater rotation
speed. This is an absolutely normal
operation, intended to provide
more effective heat dispersal. At
the end of the pyrolytic cycle, the
fans will continue to operate for
long enough to avoid overheating
the walls of adjacent units and the
front of the oven.
If the pyrolytic cycle gives
unsatisfactory results at minimum
duration, it is recommended to set
a longer time for successive
cleaning cycles.
83