10.2 CLOSE THE ANGLE LOCKS AND MOVE PINS TO STORAGE
STEPS:
•
With the VT completely secured, lower the array until the front wheels of the VT touch the ground. The array should start to roll
1
backwards slightly and, as the array is lowered, the inter-enclosure angles of the bottom four boxes will close to the 10-degree
position.
•
Once the lowest four boxes are entirely collapsed and the gap between cabinets four and five from the bottom is closed, set
2
the angle selection QRPs on the bottom four A8 cabinets to the 10-degree STORAGE position.
•
Close all eight RED Locking latches.
3
•
Remove the rear QRPs joining the fourth and fifth cabinets from the ground. These QRPs should move easily, as the weight of
4
the array is being held by the front wheels of the Vertical Transporter resting on the ground.
•
Raise the array and allow the four A8 cabinets to roll forward until the cart is resting safely on all four wheels. When the A8
5
cabinets on the VT reach this position, stop lifting the array. Remove the front QRPs and separate the suspended array from
the stack on the Vertical Transporter cart.
1
4
2
3
47
VTX A8 | Rigging Manual
5