GMC 1994 Yukon Owner's Manual page 298

Front Parkingflurn Signal Lights with
Sealed Beam Headlights
I . Remove the
two screws at the inside edge of the parkingkurn signal
light assembly.
2. Remove the light assembly by swinging
it
out from the inside edge and
sliding it out at the outside edge.
3.
Squeeze the tab on the side of the light socket while turning the socket
to the left.
4. Pull the socket out of the light assembly.
5. Push in gently on the bulb, turn it to the left and remove it from the
socket.
6. Put the new bulb in the socket, gently press in on the bulb and turn it to
7. Put the socket back into the light assembly and turn
it
socket to the
the right until it is tight.
right until it locks.
8. Put the parking/turn signal light assembly back into the vehicle and
tighten the screws.
Front Parkingflurn Signal Lights with
Composite Headlights
7
-7
1. Remove the
screws and take
out the
parkingkurn
signal light
assembly.
on the side of the
light socket while
turning the socket
to the left.
2. Squeeze the tab
6-52