Ford 1996 Taurus Manual page 24

To unfasten the belt, push the release button on
the end of the buckle. This allows the tongue to
unlatch from the buckle.
The lap belts should fit snugly and as low
as possible around the hips, not around
the waist.
Safety Belt Extension Assembly
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
This assembly is not for use in the wagon
rear-facing seat.
The use of the safety belt extension in the
wagon rear-facing seat will increase the
risk of personal injury.
Use only extensions manufactured by the same
supplier as the safety belt. Manufacturer
identification is located at the end of the
webbing on the label. Also, use the safety belt
extension only if the safety belt is too short for
you when fully extended. Do not use extension
to change the fit of the shoulder belt across the
torso.
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
22
RWARNING
RWARNING
RWARNING