Table of Contents
Advertisement
9.8 Dismantling the trigger switch
S/N 2015100001 –
1
Dismantle the drive wheel cover, saw chain and
bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Carefully loosen the connector from the self-adhe-
sive tape and move the connector and cable to the
side. See figure 1.
3
Remove the trigger switch.
Detach connector (B) using a small screwdriver to
carefully free the heels (C) on each end of the con-
nector and tigger switch.
NOTE! Do not pull the wires.
See figure 2.
Cleaning and inspection
Clean and check the trigger switch. The trigger
switch must always be replaced with a new one if
cracked or showing signs of other defects. Always
use original spare parts.
Fig 1
C
C
Fig 2
Repair Instructions
B
29
English –
Advertisement
Table of Contents
