Table of Contents
Advertisement
Repair Instructions
WARNING!
The battery must always be removed
for service/repair work and may only
be replaced once the chain saw has
been completelyassembled again!
NOTE!
Note how wires, components, etc., are posi-
tioned before dismantling.
Make sure to position them correctly to avoid
pinching when the chain saw is reassembled.
9.2 Dismantling the motor
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Remove the screws (4x).
See figure 1.
3
Press in catch (A) and unplug the connector (B).
Insert a screwdriver (C) above the connector (D)
and carefully press down to release and unplug the
connector. Remove the motor.
NOTE! Connector (B) must not be forced. Use a
screwdriver to carefully unplug the connector.
See figure 2.
Cleaning and inspection
Clean and check the motor. The motor must
always be replaced with a new one if cracked or
showing signs of other defects. Always use original
spare parts.
See figure 3.
Clean and check the motor attachments.
The crankcase half must be replaced with a new
one if the motor attachments are damaged.
Always use original spare parts.
See figure 4.
24 –
English
9.1 Repair instructions
Fig 1
Fig 2
Fig 3
Fig 4
B
C
A
D
Advertisement
Table of Contents
