Dismantling The Start/Stop Switch; Assembling The Start/Stop Control; Resistance Test - Stop Function - Husqvarna Zenoah GZ2700T Workshop Manual

6.6 Dismantling the stop switch
1
Dismantle the start/stop switch with a screwdriver.
See Figure 13.
2
Check that the stop switch is intact.
Cleaning and checking
• Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
6.7 Assembling the stop switch
1
Fit the cables. See Figure 14
2
Press the stop switch into its holder as outlined in
Figure 15.

6.8 Resistance test - stop function

1
Dismantle the stop switch. See section 6.6 Disman-
tling the stop switch.
2
Clean the contact areas and test the resistance.
3
Connect a multimeter to the ignition switch's cable
connectors. See Figure 16.
NOTE! The power switch must be held
in the "Stop" position to get the correct
reading.
The resistance must not exceed 0.2 Ohm with
the stop switch is placed in the "Stop" position.
Fig 13
Fig 14
Fig 15
Fig 16
Safety equipment
17
English –