Husqvarna T536 Li XP Workshop Manual page 52

Troubleshooting Appendix
1. Power connectors
Make sure connectors are free from dirt and that
metal surfaces are not damaged. Pay certain at-
tention to the connection tabs. Power connectors
have the same basic design on product, battery
and charger. Only colors may vary.
2. New generation keypad connector
Make sure the that there are no broken or dama-
ged wires. (Pic 2).
3. Trigger switch signal connector
Make sure the white female connector is fully
attached to the trigger switch. Look for broken or
loose cables. Also look for signs of water, corrosion
or shortcirquit on connector and pins when disas-
sembled. (Pic 3)
4. Trigger switch signal connector with
grease
Apply grease between the specifi ed pins, e.g on
T536Li XP grease should be applied between pin
1,2 and 3,4 inside as well as outside. (Pic 4, 5).
52 –
English
13 Troubleshooting Appendix
S/N 2015100001 –
Pic 1
Pic 2
Pic 3
Pic 4