Firmware Upgrades
Firmware for the RGB-DVI 300 or RGB-HDMI 300 can be
upgraded using the Extron Firmware Loader utility by
following the steps below:
1. Power on the scaler and a computer with internet access.
2. Connect the computer to the video scaler through either
the front Config port or the rear RS-232 captive screw
connectors.
3. If necessary, install the Extron Firmware Loader utility.
This is on the software disk that ships with unit or can be
downloaded, free of charge, from the Extron web site
(www.extron.com).
4. From the same site, download the firmware for the scaler.
To download either the Firmware Loader or the firmware
for the scaler, click on the Download tab on the Extron home
page:
Make a note of the folder in which the firmware file is saved.
The file name is in the format RGB_XXX_300_v1.01.BIN.
N
5. Open the Extron Firmware Loader by clicking on
the desktop icon.
RGB-DVI 300 and RGB-HDMI 300 • Serial Communications
The same firmware can be used with either the
RGB-DVI 300 or the RGB-HDMI 300.
4-19