Error Messages - Extron electronics RGB-DVI 300 User Manual

The parameters saved in memory presets and input presets are:
User Presets
Contrast
Brightness
Detail
X2)
— Test patterns:
X2!
— RGB delay (0 to 50 in tenths of a second – 0 to 5 seconds;
default 0.5 seconds). The screen blanks during transition
between inputs of different resolutions, to avoid glitches.
X2@
— On-screen menu time out in seconds (default = 10)
0 = menu never times out; 1 to 64 in seconds
X2#
— Horizontal and Vertical Frequencies (format is three
digits with single decimal and leading zeros).
X2$
— Internal temperature (in degrees Celsius)
X2%
— Off/disabled (0) or on/enabled (1)
X2^
— Overscan: applied only to SMPTE (480p - 1080p) input
rates.
0 = 0% (Default for RGB input type) A "true" auto image
is executed on SMPTE inputs
1 = 2.5% (Default for YUV input type) An auto image
command will snap to a 2.5% table; no true auto image
2 = 5% An auto image command will snap to a 5% table;
no true auto image
X2&
User Preset Availability: 0 = empty; 1 = saved
—

Error messages

E10 = Invalid command
E11 = Invalid preset number
E13 = Invalid parameter
N
RGB-DVI 300 and RGB-HDMI 300 • Serial Communications
H position
V position
H size
V size
Zoom
0 = Off (default)
1 = Color Bars
2 = Grayscale
3 = 4 x 4 Crosshatch
4 = Alternating Pixels
If the RGB-DVI 300 or RGB-HDMI 300 does not
support or recognize the entered commands, nothing will
happen and no response is issued.
Input Presets
Input type H start
Total Pixel V start
Contrast H active
Brightness V active
Detail Phase
5 = Crop
6 = 1.33 Aspect Ratio
7 = 1.78 Aspect Ratio
8 = 1.85 Aspect Ratio
9 = 2.35 Aspect Ratio
E14 = Not valid for this config.
E17 = Invalid command for signal type
E22 = Busy
H position
V position
H size
V size
Zoom
4-5