Under-Desk/Wall Mounting - Extron electronics RGB-DVI 300 User Manual

Installation, cont'd

Under-desk/wall mounting

Mount the unit under a desk or podium or to a wall, using
the optional Extron MBU 125 under-desk mounting kit
(part # 70-077-01) as follows:
1.
2.
N
Under-desk mounting
3.
4.
5.
6.
7.
RGB-DVI 300 and RGB-HDMI 300 • Installation
2-4
Remove rubber feet if these have been attached.
Secure the mounting brackets to the scaler, using the four
4-40 x 3/16" screws provided.
Because of the position of the mounting holes, the
units must be mounted upside-down under the desk or
podium, or with the bottom surface facing the wall.
Hold the unit, with the brackets attached, against the wall
or under the table or other furniture. Mark the location of
the bracket s' screw holes on the mounting surface.
Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6.3 mm) deep in the mounting surface at the marked
screw locations.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
Guide the mounting screws through the slots in the
brackets and place the unit tight against the surface.
Slide the unit slightly in or out so that the brackets are
resting on the screws and support the weight of the unit;
tighten all four screws to secure the unit in place (see the
figure above).