Symbols Used In This Manual - Extron electronics RGB-DVI 300 User Manual

Symbols used in this manual

When programming in the field, certain characters are most
conveniently represented by their hexadecimal rather than
their ASCII values. The table below shows the hexadecimal
equivalent of each ASCII character:
ASCII to HEX Conversion Table
Space
]
— carriage return with line feed
}
— carriage return (no line feed)
• —
E
— Escape key
The
the fields of the command response table (see page 4-6).
X!
— Input video format: 1 = RGB (default)
X@
— Auto image, blanking, freeze or executive mode status:
X#
— Horizontal start value: from 0 to 255 (the midpoint of 128
X$
— Vertical start value: from 0 to 255 (the midpoint of 128 is
X%
— Pixel phase value: from 1 to 31 (default = 16)
X^
— Total pixels value for high resolution video is the default
X&
— Active pixels value for high resolution video is the
X*
— Active lines value for high resolution video is the default
X1)
— Picture adjustment (contrast, brightness, and detail):
RGB-DVI 300 and RGB-HDMI 300 • Serial Communications
space character
X/
values defined in this section are the variables used in
0 = disabled
is the default value in the input lookup tables)
the default value in the input lookup tables)
value ± 512 (the default value depends on the the input
resolution)
default value ± 512 (the default value depends on the the
input resolution)
value ± 256 (the default value depends on the the input
resolution)
from 0 to 127 (default = 64)
.
1 = enabled
2 = YUV
4-3