Hussmann KH14 Installation Manual page 7

PRODUCT INSTALLATION MANUAL
Cases must be positioned so that line-up numbers and case sequence numbers run in succession left to right standing in
front of the cabinet.
To position the cases:
1. If the plinth surface is level, position the case designated as line up number 1 and case sequence number 1 in the
required position.
2. If the plinth surface is not level, determine where the highest point of the plinth is, and position the case allocated
to this position first.
3. Adjust the case height using the adjustable feet (if fitted) or metal shims (do NOT use timber) to ensure the case
is level to within +/- 1.5mm from front to back and side to side and chassis of case is NOT twisted. Maximum
25mm adjustment.
_________________________________________________________________________________________________________________________
Page 6
CAUTION
Ensure the lifting capacity of the trolley, etc. is
sufficient for the case.
engineering data tables and Risk Analysis (page 20).
Fig (4) Levelling feet adjustment
NOTE
It is important that all cases are level for correct case joining and operation. If
cases are not properly levelled and positioned, door misalignment will be evident,
resulting in the job needing to be redone at complete cost to the installer.
Hussmann is not liable or responsible for the cost involved in fixing
problems arising directly from the installers' failure to follow the
requirements outlined in this manual.
DO NOT SET CASE LEVELS OFF THE PATCH END fitted to a case.
KH14 SELF SERVE HOT FOOD
Refer to the product
Hussmann