Connection To A Dut; Connection To A Dut With An External Dc Power Supply - Agilent Technologies E5091A User Manual

Multiport test set

Table of Contents

Setting the Instrument

Setting control line

Connection to a DUT

The Figure 3-7 shows an example of the connection between the DUT and the E5091A

without an external dc power supply. Input the signals from the pin 12 and 15 to Positive

Input and Negative Input respectively and connect each line to the control terminal of the

DUT.

CAUTION

The path that can be short is between the pin 12-13 and the the pin 14-15. Don't

short-circuit another path because it may be cause of faults.

Figure 3-7

Connecting the E5091A to the DUT

The Figure 3-8 shows an example of the connection between the DUT and the E5091A

with an external dc power supply. Input the High and Low signals from the external power

supply to Positive Input and Negative Input respectively and connect each line to the

control terminal of the DUT.

Perform the procedure "Turning on the E5091A → Connecting the DUT → Turninig on

CAUTION

the external power supply". To turning off, perform the reverse procedure of it. The

E5091A may break down if a dc current pass through the E5091A when it is turned off.

CAUTION

Don't short-circuit between pins because it may be cause of faults.

Table of Contents