Rear Panel - Agilent Technologies E5091A User Manual

Product Overview
Name and function of each part

Rear panel

The name and overview of each part on the rear panel of the E5091A are as follows.
Figure 2-2 Rear panel
1. USB port
Used to connect the USB cable to the rear panel of the ENA Series RF Network Analyzers.
NOTE
Connecting devices other than the ENA Series RF Network Analyzers to the USB port is
not supported.
2. ID bit switch
The bit switch to set the ID of the E5091A required for control from the ENA Series RF
Network Analyzers. You can set it to 1 or 2. It is set to 1 when shipped from the factory.
3. Serial number plate
The serial number of the E5091A is printed.
4. Power cable inlet
The inlet to which the power cable is connected.
30 2