Start-Up; Operating Modes - KBL megaSun space 2000 Operating Instructions Manual

Start-up

Before switching on for the first time:
• Fix the supplied warning sign or one with the
following wording permanently to the wall close to
the tanning device:
Warning!
• UV-radiation can cause eye and skin damage
as well as skin aging and possibly skin cancer.
Ask the studio staff for further information.
• Wear protective goggles.
• Certain medicines or cosmetics can increase
the sensitivity of the skin to UV radiation. If in
doubt, consult a physician.
• Determine the presettings for the tanning device in
the service menu.
• Check correct installation of fluorescent tubes. The
tube labeling must be visible, otherwise no tanning
effect may be obtained.
• Store these Operating Instructions in a place that
allows for easy access at any time.

Operating modes

The three different operating modes and the fan
run-on mode are explained below:
STANDBY MODE
The tanning device is in an idle state, i.e. it is
connected to the mains but is currently not being
used. The tubes switched off. From the standby
mode, you can change over to the tanning mode or
to the service mode.
TANNING MODE
The tubes are switched on and a tanning session is
in progress. While the tanning device is in tanning
mode, the settings for the ongoing tanning session
can be changed via the interior control panel.
SERVICE MODE
In the service mode, the tanning device is configured
for the tanning mode. Various values can be displayed
and test functions can be carried out.
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the tanning device.
The fan power is automatically decreased as the
tubes cool down.
O p e r a t i n g I n s t r u c t i o n s | megaSun space 2000
13