Table of Contents
Advertisement
3-17. S Load Gear, T Load Gear,
S Load Lever Assembly and
T Load Lever Assembly
1. Refer to Section 3-16 and remove the crescent slide.
2. Refer to Section 3-14-2 and remove the S and T
incline mounting assemblies.
3. Remove the clamp 1, then remove the components:
the S load gear 2, the S load spring 3 and the S load
lever assembly 4. When you do this, be careful not to
damage the clamp 1, which can be damaged easily.
Again, be careful when you disassemble the compo-
nents, as the S load spring 3 will spring out.
4. Remove the following components: the T load gear
5, the T load spring 6, and the T load lever assem-
bly 7. Be careful when you disassemble the compo-
nents, as the T load spring 6 will spring out.
Assembly Notes:
1. Apply grease (VHJ-0100) to the shafts 8, 9 and
parts A shown in Fig. 3-17-1. Then apply grease
(VHJ-0100) to the parts shown in Fig. 3-17-2.
2. When fitting the S load gear 2 and the T load gear 5
align them in the tape-loaded state, as shown in Fig. A
in Fig. 3-17-3. Again, after completing tape-unloading
on these gears, check that they are positioned as shown
in Fig. B in Fig. 3-17-3, then refer to Section 3-14-2
and fit the S and T incline mounting assemblies.
7 T load lever
assembly
6 T load
spring
5 T load
gear
Parts A
(apply
grease here)
Fig. 3-17-1
2-30
4
S load lever
assembly
3 S load spring
1 Clamp
2 S load
gear
8 Shaft
9 Shaft
(T side)
Apply
grease here
Apply
grease inside
the hole
Apply grease to the gears
(S side)
Apply
grease
here
Apply grease inside
Apply
the hole
grease here
Fig. 3-17-2
Fig. A: When tape loading is complete
T load gear
Fig. B: When tape unloading is complete
T load gear
Fig. 3-17-3
Apply
grease here
S load gear
S load gear
SVT-RA40/RA168
Advertisement
Chapters
Table of Contents
