S Brake Act Slide And Bt Spring Lever Assembly - Sony SVT-RA40 Service Manual

3-13-3. S Brake Act Slide and BT Spring
Lever Assembly
1. Refer to Section 3-16 and remove the crescent slide.
2. Refer to Section 3-12-1 and remove the friction gear
assembly.
3. Slide the S brake act slide 1 in the direction of the
arrow A, then remove it.
4. Refer to Section 3-11 and remove the BT spring.
5. Remove the sub BT spring 2.
6. Press the BT spring lever assembly 3 until it touches
the pin 4, then remove it.
Assembly Notes:
1. Apply grease (VHJ-0100) to the shaft 5 shown in
Fig. 3-13-3, and to the BT spring lever assembly 3
and the S brake act slide 1 shown in Fig. 3-13-4.
2. After mounting the BT spring lever assembly 3 on
the Shaft 5, hook the BT spring onto the clamp 6
and press it until it touches the pin 7.
3. Make sure that the clamps 8, 9 and 0 have
snapped into the S brake act slide 1. Align the arrow
!- on the S brake act slide 1 with the arrow != on
the mechanism chassis.
2-26
!= Arrow on
mechanism chassis
1 S brake act
slide
8 Clamp
0 Clamp
9 Clamp
Fig. 3-13-3
Apply
grease
1
S brake
act slide
Apply grease
Fig. 3-13-4
3 BT spring
lever
2 Sub BT
assembly
spring
!- Arrow
6 Clamp
5 Shaft
7 Pin
4 Pin
Apply grease
3 BT spring
lever
assembly
SVT-RA40/RA168